Removal Procedure
Caution: Refer to SIR Caution in the Preface section.
- Disable the SIR system. Refer to
SIR Disabling and Enabling
in SIR.
- Remove the knee bolster. Refer to
Driver Knee Bolster Panel Replacement
in Instrument Panel, Gages,
and Console.
- Remove the lower trim cover. Refer to
Steering Column Trim Covers Replacement
.
- Disconnect the electrical connector from the tilt actuator assembly.
- Remove the fasteners (3) from the tilt actuator assembly.
- Remove the tilt actuator assembly (2) from the steering
column.
- Remove the potentiometer housing (1) from the tilt actuator
assembly.
- Disconnect the tilt cable
from the tilt actuator assembly.
Installation Procedure
- Install the black end
of the tilt actuator cable assembly to the steering column.
- Install the potentiometer
housing (1) to the tilt actuator assembly (2).
- Install the white end of the tilt actuator cable to the tilt actuator
assembly.
Notice: Refer to Fastener Notice in the Preface section.
- Install the tilt actuator assembly and the retaining screws.
Tighten
Tighten the screws to 1.5 N·m (13 lb in).
- Connect the electrical connector to the tilt actuator.
- Install the lower trim cover. Refer to
Steering Column Trim Covers Replacement
.
- Install the knee bolster. Refer to
Driver Knee Bolster Panel Replacement
in Instrument Panel, Gages,
and Console.
- Enable the SIR system. Refer to
SIR Disabling and Enabling
in SIR.