GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2005 🢒 XLR 🢒 Bulletins 🢒 Rear Wheel Drive Shaft Nut Torque Specification Requirements and Information on Replacement Shafts for Service

Rear Wheel Drive Shaft Nut Torque Specification Requirements and Information on Replacement Shafts for Service

Subject:Rear Wheel Drive Shaft Nut Torque Specification Requirements and Information on Replacement Shafts For Service

Models:2004-2006 Cadillac XLR
2005-2006 Chevrolet Corvette


Rear Wheel Drive Shaft Nut Torque Procedure

Notice: 

   • If service requires the removal and reinstallation of the rear wheel drive shaft retaining nut, it is CRITICAL to follow the torque procedure below. Failure to follow the torque procedure may result in a inadequate torque specification.
   • If service requires removal and reinstallation of the rear wheel drive shafts, clean the inboard mating surface of the wheel bearing and the mating surface of the axle shaft of any foreign material prior to assembly. Failure to properly clean the mating surface may result in an inadequate torque specification.


Object Number: 174557 Size: SH
  1. Insert a drift or punch into the brake rotor cooling fins and against the caliper to prevent the wheel hub and bearing from turning.
  2. Begin to install the drive shaft retaining nut onto the drive shaft by hand.
  3. Slowly tighten the nut to draw the drive shaft to the wheel hub and bearing.

    4. Tighten
    Tighten the drive axle spindle nut to 160 N·m (118 lb ft).

  4. Remove the drift or punch.

Refer to Wheel Drive Shaft Replacement (SI Document ID 1715538) for additional information.

Rear Wheel Drive Shaft Assembly Available for Service

Notice: 

   • If service requires the removal of the rear wheel drive half shaft retaining nut, it is CRITICAL to follow the torque procedure above. Failure to follow the torque procedure may result in a inadequate torque specification.
   • If service requires the replacement of the rear wheel drive shafts, clean the inboard mating surface of the wheel bearing and the mating surface of the axle shaft of any foreign material prior to assembly. Failure to properly clean the mating service may result in an inadequate torque specification.

If service requires the replacement of the rear wheel drive shaft assembly, it is no longer recommended to use the following P/Ns for service. The following P/Ns have been removed from GMSPO stock.

    • P/N 15281031
    • P/N 10350598
    • P/N 10350599

GMSPO has released a newly designed rear wheel drive shaft assembly for service.

If service requires the replacement of the rear wheel drive shafts, use only the P/Ns listed in the Parts Information table below .

Parts Information

Part Number

Description

15851726

SHAFT, RR WHL DRIVE SHAFT

04-06 XLR

05-06 Corvette without RPO Z06

BOTH RIGHT AND LEFT SIDES

15854748

SHAFT, RR WHL DRIVE SHAFT

06 XLR-V (BOTH SIDES)

06 Corvette with RPO Z06 (RIGHT SIDE ONLY)

15862007

SHAFT, RR WHL DRIVE SHAFT

06 Corvette with RPO Z06 (LEFT SIDE ONLY)