GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2007 🢒 XLR 🢒 Engine 🢒 Engine Mechanical - 4.4L 🢒 Crankshaft Balancer Replacement

Tools Required

    •  J 45059 Angle Meter
    • J 41816 Crankshaft Balancer Remover
    • J 41998-B Crankshaft Balancer Installer
    • EN 46326 Flywheel Holding Tool

Removal Procedure
  1. Remove the water pump and generator drive belt. Refer to Water Pump and Generator Belt Replacement .
  2. Remove the supercharger drive belt. Refer to Supercharger Belt Replacement .
  3. Remove the air conditioning and power steering drive belt. Refer to Air Conditioning Compressor and Power Steering Pump Belt Replacement .
  4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  5. Remove the power steering gear. Refer to Steering Gear Replacement .

    6. Object Number: 928040 Size: SH
  6. Remove the starter motor. Refer to Starter Motor Replacement .
  7. Install the EN 46326 .

    8. Object Number: 928046 Size: SH
  8. Remove the crankshaft balancer bolt.

    9. Object Number: 928048 Size: SH
  9. Place the remover pilot into the end of the crankshaft.
  10. Install the J 41816 on the crankshaft balancer.

    11. Object Number: 928051 Size: SH
  11. Remove the crankshaft balancer using the J 41816 .
  12. Ensure that you do not lose the oil pump drive to crankshaft balancer friction washer. The friction washer may come off with the balancer.
  13. Clean and inspect the crankshaft balancer. Refer to Crankshaft Balancer Cleaning and Inspection .

Installation Procedure
  1. Ensure that the oil pump drive to crankshaft balancer friction washer is installed.

    2. Object Number: 928051 Size: SH
  2. Position the crankshaft balancer on the nose of the crankshaft.

    3. Object Number: 948118 Size: SH
  3. Press the crankshaft balancer in place using the J 41998-B .

    4. Object Number: 928046 Size: SH
  4. Clean the crankshaft balancer bolt threads.
  5. Apply engine oil to the crankshaft balancer bolt threads.

    6. Notice: Refer to Fastener Notice in the Preface section.

  6. Install the crankshaft balancer bolt.
    7. 6.1. First Pass

    Tighten
    Tighten the crankshaft balancer bolt to 50 N·m (37 lb ft).

    6.2. Final Pass

    Tighten
    Tighten the crankshaft balancer bolt an additional 120 degrees using the J 45059 .

  7. Install the steering gear. Refer to Steering Gear Replacement .

    8. Object Number: 928040 Size: SH
  8. Lower the vehicle.
  9. Remove the EN 46326 .
  10. Install the starter motor. Refer to Starter Motor Replacement .
  11. Install the air conditioning and power steering drive belt. Refer to Air Conditioning Compressor and Power Steering Pump Belt Replacement .
  12. Install the supercharger drive belt. Refer to Supercharger Belt Replacement .
  13. Install the water pump and generator drive belt. Refer to Water Pump and Generator Belt Replacement .