DEFINITION: The steering wheel does not return to center after completing a turn.

Did you review the General Description and perform the necessary inspections?

Go to Step 2

Go to Symptoms - Suspension General Diagnosis

Verify that memory steer is present.

Does the system operate normally?

System OK

Go to Step 3

Ensure that all of the tires are inflated to the correct pressure. Refer to Vehicle Certification, Tire Placard, Anti-Theft, and Service Parts ID Label.

Has the inspection/adjustment been performed?

Go to Step 4

--

1. Lubricate the tie rod ends and the ball joints if applicable.
2. Inspect the suspension system for worn or damaged components.
3. Repair as necessary.
4. Road test the vehicle in order to verify the customer complaint.

Does the vehicle still exhibit memory steer?

Go to Step 5

System OK

1. Check for proper wheel alignment. Refer to Wheel Alignment Measurement. Adjust as necessary.
2. Road test the vehicle in order to verify the customer complaint.

Does the vehicle still exhibit memory steer?

Go to Step 6

System OK

1. Raise and support the vehicle. Refer to Vehicle Certification, Tire Placard, Anti-Theft, and Service Parts ID Label .
2. Disconnect both of the outer tie rod ends from the steering knuckles. Refer to Rack and Pinion Outer Tie Rod End Replacement.
3. Use your hands in order to move the tie rod ends.

Are either of the tie rod ends abnormally difficult to move?

Go to Step 7

Go to Step 8

Replace the outer tie rod end(s) as necessary. Refer to Rack and Pinion Outer Tie Rod End Replacement .

Did you complete the repair?

Go to Step 14

--

1. Remove the tire/wheel.
2. Disconnect the lower control arm from the steering knuckle.
3. Use your hands to rotate the ball joint stud.

Is the ball joint abnormally difficult to rotate?

Go to Step 9

Go to Step 10

Replace the lower control arm. Refer to Lower Control Arm Replacement.

Did you complete the repair?

Go to Step 14

--

1. Raise and support the vehicle. Refer to Vehicle Certification, Tire Placard, Anti-Theft, and Service Parts ID Label .
2. Rotate the steering wheel ONE revolution in either direction.
3. Rotate the steering wheel back to the original position.

Was the steering wheel abnormally difficult to rotate in either direction?

Go to Step 11

Go to Step 14

1. Disconnect the intermediate shaft.

Important: Do NOT rotate the steering wheel more than one complete revolution.

2. Note the position of the steering wheel and rotate the steering wheel ONE revolution in either direction.
3. Rotate the steering wheel back to the original position as previously noted.

Was the steering wheel abnormally difficult to rotate in either direction?

Go to Step 12

Go to Step 13

1. Repair the steering gear as necessary. Refer to Steering Gear Replacement.
2. Road test the vehicle in order to verify the customer complaint.

Did you complete the repair?

Go to Step 14

--

Repair the steering column as necessary.

Did you complete the repair?

Go to Step 14

--

Operate the vehicle in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3