Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC B3265 01 : Trunk Release Output Circuit Short to BatteryDiagnostic Fault Information
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
Trunk Key Switch Signal | 1 | 1 | 1 | -- |
Trunk Release Control Signal | 1 | 1 | B3265 | -- |
Trunk Release Switch Signal - Exterior | B3618 | 1 | 1 | -- |
Trunk Release Switch Signal - Interior | 1 | 1 | 1 | -- |
Rear Compartment Lid Pull Down Actuator Signal | B1297 | B1297 | B1297 | -- |
Rear Compartment Lid Pull Down Actuator B+ | 1 | 1 | 1 | -- |
Rear Compartment Lid Release Close Switch B+ | 1 | 1 | B3641 | -- |
Trunk Release Switch Supply Voltage | 1 | 1 | 1 | -- |
Rear Compartment Lid Pull Down Actuator Ground | 1 | 1 | 1 | -- |
Rear Compartment Lid Release Switch Exterior Ground | 1 | 1 | 1 | -- |
Rear Compartment Lid Release Switch Interior Ground | 1 | 1 | 1 | -- |
Rear Compartment Lid Release Close Switch Ground | 1 | 1 | 1 | -- |
1. Trunk Release Inoperative | ||||
Circuit/System Description
The body control module (BCM) grounds the trunk release control signal circuit based on trunk release switch signal from either the interior rear compartment lid release switch or the exterior rear compartment lid release switch. The rear compartment lid pull down actuator is supplied battery voltage at all times via the TRUNK LATCH fuse. When either the interior or exterior rear compartment lid release switch is pressed, the trunk release switch signal circuit is grounded. This input will request the BCM to momentarily ground the trunk release control signal circuit, which will open the rear compartment lid. For more detailed information concerning trunk release operation refer to Luggage Compartment Description and Operation .
Conditions for Running the DTC
The rear compartment lid release is active.
Conditions for Setting the DTC
| • | The BCM detects a short to battery on the trunk release control signal circuit. |
| • | The condition is present for more than 125 ms. |
Actions Taken When the DTC Sets
The BCM disables the rear compartment lid release for the duration of the ignition cycle.
Conditions for Clearing the DTC
| • | The condition responsible for setting the DTC no longer exists. |
| • | You issue a scan tool CLEAR DTCs command. |
| • | A history DTC will clear after 50 malfunction-free ignition cycles. |
Reference Information
Schematic Reference
Connector End View Reference
Vehicle Access Connector End Views
Electrical Information Reference
Scan Tool Reference
Circuit/System Testing
- Ignition OFF, disconnect the rear compartment lid pull down actuator.
- Verify that a test lamp does not illuminate when connected between the trunk release control signal circuit terminal B and ground.
- If all circuits test normal, test or replace the rear compartment lid pull down actuator.
| ⇒ | If the test lamp illuminates, test for a short to voltage on the trunk release control signal circuit. If the circuit tests normal, replace the BCM. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
| • | Control Module References for BCM replacement, setup, and programming |
