Removal Procedure
- Open
the door on the instrument panel (I/P) passenger compartment.
- Disconnect the door dampener.
- Disconnect the electrical connector from the I/P compartment lamp switch.
- With the compartment open, depress both rear corners of the compartment
and swing the compartment down towards the floor.
- Starting at the outboard side, release the compartment hinge from the
pin at the bottom of the door.
- Slowly pull the I/P compartment far enough to disconnect the wiring harness
connector from the inflatable restraint module switch.
- Remove the I/P compartment.
Installation Procedure
- Connect the wiring harness
connector to the inflatable restraint module switch connector.
- Align the I/P compartment to the lower I/P carrier pins.
- Starting at the inboard side, push on the compartment to engage the pin
to the I/P compartment hinge.
- Depress the I/P compartment back corners and swing the compartment upward
into the I/P. Release the corners.
- Connect the electrical connector to the I/P compartment lamp switch.
- Close the I/P passenger compartment door.