Removal Procedure
- Remove the intake manifold. Refer to
Intake Manifold Replacement
.
- Disconnect the crankshaft position sensor electrical connector.
- Remove the crankshaft sensor retaining bolt.
- Remove the crankshaft sensor.
Installation Procedure
Important: Inspect the crankshaft sensor O-ring for wear or damage. If a problem is found, replace the O-ring.
- Lubricate the crankshaft sensor O-ring with clean engine oil.
Notice: Refer to Fastener Notice in the Preface section.
- Install the crankshaft sensor and the retaining bolt.
Tighten
Tighten the retaining bolt between 10 N·m (89 lb in).
- Connect the crankshaft position sensor electrical connector.
- Install the intake manifold. Refer to
Intake Manifold Replacement
.
- Operate the engine and inspect crankshaft sensor for engine oil leaks.
- Perform the
Crankshaft Position System Variation Learn
.