Removal Procedure
- Remove the right rear wheelhouse liner panel. Refer to
Rear Wheelhouse Panel Liner Replacement
.
- Remove the EVAP canister access cover.
- Disconnect the fuel tank pressure sensor electrical connector (1) located on the right side fuel tank
module.
- Remove the fuel tank pressure sensor (1) by carefully prying the sensor out of the fuel tank.
Installation Procedure
- Lubricate the fuel tank pressure sensor rubber grommet with clean engine oil in order to aid in installation.
- Install the fuel tank pressure sensor (1) into the top of the fuel tank module.
- Connect the fuel tank pressure sensor electrical connector (1).
- Install the EVAP canister access cover.
- Install the right rear wheelhouse liner panel. Refer to
Rear Wheelhouse Panel Liner Replacement
.