Removal Procedure
- Raise the vehicle. Refer to
Lifting and Jacking the Vehicle
.
- Disconnect the vacuum line fitting (4) from the flow control valve solenoid. The graphic shows the rear fascia removed for clarity.
- Disconnect the vacuum line fittings (1 and 3) from the flow control valves.
- Disengage the retainer clips along the length of the vacuum line (2).
- Remove the vacuum line from the vehicle.
Installation Procedure
Important: Do NOT remove the thermal wrap insulation from the vacuum hose.
- Install the vacuum line to the vehicle.
- Install the retainer clips along the length of the vacuum line (2).
- Connect the vacuum line fittings (1 and 3) to the flow control valves.
- Connect the vacuum line fitting (4) to the flow control valve solenoid.
- Lower the vehicle.