Tools Required
EN 46328
Camshaft Holding Tool
- Remove the
EN 46328
from the left camshafts.
- Place a small amount of sealant GM P/N 12378521 (Canadian P/N 88901148)
or equivalent at the split line of the left cylinder head and the left camshaft position actuator housings.
Important: Be careful to prevent the exposed section of the camshaft cover seal from being damaged by the edge of the cylinder head casting.
- Install the left camshaft cover.
- Install the NEW camshaft cover bolt grommets prior to installing the camshaft cover bolts.
Notice: Refer to Fastener Notice in the Preface section.
- Install the left camshaft cover bolts.
Tighten
Tighten the left camshaft cover bolts to 10 N·m (89 lb in).
- Install the bolts connecting the left camshaft cover ground strap to the left
cylinder head and the left camshaft cover.
Tighten
• | Tighten the left ground strap bolt into the camshaft cover to 10 N·m (89 lb in). |
• | Tighten the left ground strap bolt into the cylinder head to 25 N·m (18 lb ft). |