Removal Procedure
- Remove the engine sight shield. Refer to
Intake Manifold Sight Shield Replacement
.
- Disconnect the actuator solenoid electrical connector.
- Remove the left intake camshaft position (CMP) actuator solenoid bolts.
- Remove the left intake CMP actuator solenoid.
Installation Procedure
Notice: DO NOT remove the camshaft position actuator magnet unless it needs
to be replaced. The camshaft position actuator magnet is precisely aligned
to the camshaft position actuator oil control valve on the end of the camshaft
during engine assembly. If the camshaft position actuator magnet is removed
and/or needs to be replaced, it will be necessary to realign the camshaft
position actuator magnet to the camshaft position actuator oil control valve
after the camshaft position actuator housing is installed to the cylinder
head. Failure to realign the camshaft position actuator magnet to the camshaft
position actuator oil control valve can lead to poor engine performance and
engine component damage.
To allow for CMP actuator solenoid to CMP actuator oil control valve alignment, DO NOT install the NEW camshaft position actuator solenoid alignment plugs at this time.
Camshaft Position Actuator Solenoid Alignment Procedure
- Make an alignment pin from drill rod 15/64 inch diameter and at least 50 mm (1.97 in) long.
- If necessary remove the black alignment plug on the actuator and verify that the alignment pin will pass through the CMP actuator solenoid alignment hole.
- Verify that the alignment pin will fit into the alignment hole in the CMP actuator oil control valve.
- Apply a 2 mm (0.079 in) bead of RTV GM P/N 12378521 (Canadian P/N 88901148) around the flange of the CMP actuator solenoid.
- Install the CMP actuator solenoid over the oil control valve.
- Install the alignment pin through the solenoid alignment hole and into the oil control valve alignment hole.
Notice: Refer to Fastener Notice in the Preface section.
- With the alignment pin in place, install the CMP actuator solenoid bolts.
Tighten
Tighten the CMP actuator solenoid bolts to 8 N·m (71 lb in).
- Remove the alignment pin.
- Install a NEW CMP actuator solenoid plug.
- Connect the electrical connector to the actuator solenoid.
- Install the engine sight shield. Refer to
Intake Manifold Sight Shield Replacement
.