GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 1614014  Size: SH
  1. Remove the engine sight shield. Refer to Intake Manifold Sight Shield Replacement .
  2. Disconnect the electrical connector (3) from the supercharger bypass regulator solenoid valve (2).
  3. Disconnect the vacuum line fittings (4, 5) from the supercharger bypass regulator solenoid valve.
  4. Remove the supercharger bypass regulator solenoid valve from the bracket.
  5. Remove the bolt (1) and bracket if necessary.

  6. Object Number: 1614017  Size: SH
  7. Inspect the bypass regulator solenoid valve vacuum supply line and fittings (1, 2). Replace the vacuum line if necessary.

  8. Object Number: 1614019  Size: SH
  9. Inspect the bypass regulator solenoid valve to bypass valve actuator vacuum line and fittings (1, 2). Replace the vacuum line if necessary.

Installation Procedure

    Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1614014  Size: SH
  1. Install the bracket and bolt (1) if previously removed.
  2. Tighten
    Tighten the supercharger bypass regulator solenoid valve bracket bolt to 9 N·m (80 lb in).

  3. Install the bypass regulator solenoid valve (2) to the bracket.
  4. Connect the vacuum line fittings (4, 5) to the bypass regulator solenoid valve.
  5. Connect the electrical connector (3) to the bypass regulator solenoid valve.
  6. Install the engine sight shield. Refer to Intake Manifold Sight Shield Replacement .