Trunk Ajar Indicator Malfunction Coupe
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category |
Diagnostic Fault Information
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
Trunk Ajar Switch Signal | 2 | 1 | 1 | -- |
1. Trunk Ajar Indicator Always Off 2. Trunk Ajar Indicator Always Illuminated | ||||
Circuit/System Description
The body control module (BCM) receives a discrete input from the trunk ajar switch signal circuit. The trunk ajar switch is integral to the rear compartment lid pull down actuator. When the trunk is opened, the normally open trunk ajar switch closes. With the trunk ajar switch closed, ground is provided to the trunk ajar switch signal circuit. The BCM interprets this and sends a serial data message to the instrument panel cluster (IPC). When the trunk is open/ajar and the vehicle is in any gear other than PARK, the driver information center (DIC) will display TRUNK AJAR. If the trunk is still ajar and the vehicles speed is greater than 5 km/h (3 mph) a chime will sound.
Reference Information
Schematic Reference
Connector End View Reference
Description and Operation
Luggage Compartment Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
Ignition ON, observe the scan tool Trunk Ajar Switch parameter and the IPC TRUNK AJAR indicator while opening and closing the trunk. The parameter should change between Trunk Closed and Trunk Ajar and the TRUNK AJAR indicator should trun ON and OFF.
| ⇒ | If the parameter changes but the TRUNK AJAR indicator is always OFF or always ON, replace the IPC. |
Circuit/System Testing
- Ignition OFF, disconnect the harness connector at the rear compartment lid pull down actuator.
- Ignition ON, verify the scan tool Trunk Ajar Switch parameter is Trunk Closed.
- Install a 3-A fused jumper wire between the signal circuit terminal A and ground. Verify the scan tool Trunk Ajar Switch parameter is Trunk Ajar.
- If all circuits tests normal, replace the rear compartment lid pull down actuator.
| ⇒ | If not the specified value, test the signal circuit terminal A for a short to ground. If the circuit tests normal, replace the BCM. |
| ⇒ | If not the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the BCM. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
| • | Control Module References for BCM or IPC replacement, setup and programming |
