Removal Procedure
- Open the rear compartment.
- Unlatch and fold the rear compartment partition.
- Remove the retaining screw from the latch trim cover on the roof lift-off panel/window.
- Pull to disengage the retaining clips from the latch trim cover.
- Disconnect the electrical connector to the switch, if equipped.
- Remove the latch trim cover from the rear compartment.
Installation Procedure
- Position the latch trim cover to the rear compartment.
- Connect the electrical connector to the switch.
- Push to engage the retaining clips to the latch trim cover on the roof lift-off
panel/window.
Notice: Refer to Fastener Notice in the Preface section.
- Install the retaining screw to the latch trim cover.
Tighten
Tighten the screw to 1.9 N·m (17 lb in).
- Fold the rear compartment partition and engage the partition to the latch trim cover.
- Close the rear compartment and verify the correct operation of the folding hard top.