For 1990-2009 cars only
Removal Procedure
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove the left front wheel. Refer to Tire and Wheel Removal and Installation .
- Remove the left front lower wheelhouse splash shield fasteners (1, 2, 3) at the rear of the wheelhouse.
- Remove the shield.
- Disconnect the output hose (4) from the washer pump. Drain the contents into a suitable container.
- Disconnect the electrical connector from the level sensor (2).
- Remove the washer solvent container level sensor (2) by twisting the sensor out of the washer solvent container.
Important: Ensure that the hoist is clear of the left front fender to allow the lower fender to be moved away for access to the washer container.
Important: Note the position of the fender for installation alignment.
Important: Note the orientation of the level sensor, with the electrical connector on top.
Installation Procedure
- Install the level sensor rubber grommet into the washer solvent container.
- Lubricate the sensor body and grommet with washer fluid, to aid in installation.
- Twist and insert the sensor body through the grommet until the sensor is seated as originally positioned.
- Connect the electrical connector (3) to the level sensor (2).
- Align and install the left front lower wheelhouse (1, 2, 3) splash shield.
- Install the left front wheel. Refer to Tire and Wheel Removal and Installation .
- Lower the vehicle.
- Refill the washer solvent container.
- Inspect the operation of the pumps and the level sensor for leaks.
