• | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
• | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
• | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
The outside rearview mirror control switch is contained within the driver door switch (DDS). The DDS sends a message to the driver door module (DDM) to move the left mirror or the passenger door module (PDM) to move the right mirror. The DDM or PDM then applies voltage and ground to the appropriate circuits of the appropriate mirror motor to move the mirror vertically and/or horizontally.
Battery voltage must be between 9-16 volts.
• | The DDS detects that the switch contacts are activated. |
• | Condition must be present for greater than 30 seconds. |
The faulted switch input will be ignored.
• | A current DTC will clear when the fault is no longer present. |
• | A history DTC will clear after 50 fault free ignition cycles. |
Outside Rearview Mirror Schematics
Outside Mirror Description and Operation
Control Module References for scan tool information
⇒ | If the DTC resets, replace the DDS. |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for DDS replacement, setup, and programming