GM Service Manual Online
For 1990-2009 cars only

Diagnostic Instructions

    • Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    • Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    •  Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC B1328: Device Voltage Circuit High

Diagnostic Fault Information

Circuit

Short to Ground

Open/High Resistance

Short to Voltage

Signal Performance

B+

B1327

B1327

--

--

Circuit/System Description

The control modules on this vehicle monitor system voltage through the battery positive voltage circuits. Damage to components, and incorrect data can occur when the voltage is out of range. This vehicle has multiple modules that will set this DTC. For more information on which modules, refer Diagnostic Trouble Code (DTC) List - Vehicle.

Conditions for Running the DTC

    • This DTC shall run only if the module has power, ground and the ignition is not in START mode.
    • This DTC shall execute regardless of the battery voltage.

Conditions for Setting the DTC

This DTC shall be set as current when the voltage raises above 16  volts for 1.2 seconds.

Action Taken When the DTC Sets

    • A message shall be sent out to notify all other modules of high battery voltage.
    • The modules disable the setting of U codes and other DTCs.

Conditions for Clearing the DTC

    • The DTC will clear current status when the voltage is less than 15.5 volts for 1.2 seconds.
    • A history DTC will clear after 50 consecutive ignition cycles if the condition for the malfunction is no longer present.

Diagnostic Aids

    • A possible cause of this DTC could be overcharging with a battery charger or jump starting.
    • A high voltage value in multiple modules indicates a concern in the charging system.

Reference Information

Schematic Reference

Control Module References

Connector End View Reference

Component Connector End Views

Description and Operation

Charging System Description and Operation

Electrical Information Reference

    •  Circuit Testing
    •  Connector Repairs
    •  Testing for Intermittent Conditions and Poor Connections
    •  Wiring Repairs

Scan Tool Reference

Control Module References for scan tool information

Circuit/System Verification

  1. Engine running measure and record the voltage at the battery terminals. The battery voltage is 12.6-15.5 volts.
  2. If the battery voltage is not within the specified range, refer to Charging System Test.
  3. Observe the appropriate control module scan tool Battery Positive Voltage parameter. The reading should be between 12.6 and 15.5 volts.
  4. If not within the specified range, replace the appropriate control module.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for the appropriate control module replacement, setup and programming