• | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
• | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
• | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
---|---|---|---|---|
Audio Amplifier B+ | 1 | 1 | -- | -- |
CD Changer B+ | 1, 2 | 1, 2 | -- | -- |
Front Center Speaker Output (+) | 1 | 1 | 1 | -- |
Front Center Speaker Output (-) | 1 | 1 | 1 | -- |
Left Front Midrange Speaker Output (+) | 1 | 1 | 1 | -- |
Left Front Midrange Speaker Output (-) | 1 | 1 | 1 | -- |
Left Front Subwoofer Speaker Output (+) | 1 | 1 | 1 | -- |
Left Front Subwoofer Speaker Output (-) | 1 | 1 | 1 | -- |
Left Seat Speaker Output (+) | 1 | 1 | 1 | -- |
Left Seat Speaker Output (-) | 1 | 1 | 1 | -- |
Right Front Midrange Speaker Output (+) | 1 | 1 | 1 | -- |
Right Front Midrange Speaker Output (-) | 1 | 1 | 1 | -- |
Right Front Subwoofer Speaker Output (+) | 1 | 1 | 1 | -- |
Right Front Subwoofer Speaker Output (-) | 1 | 1 | 1 | -- |
Right Seat Speaker Output (+) | 1 | 1 | 1 | -- |
Right Seat Speaker Output (-) | 1 | 1 | 1 | -- |
Audio Amplifier Ground | -- | 1 | -- | -- |
CD Changer Ground | -- | 1, 2 | -- | -- |
1. Speaker Malfunction 2. Compact Disk Inoperative |
The CD changer is supplied with battery voltage from the RADIO, S-BAND/VCIS fuse located in the body control module (BCM). The radio provides the CD changer with right and left low level audio signal circuits (+) and (-). The audio signal circuits are DC bias voltage circuits that are one half of the battery voltage. When using a DMM, each of the audio signal circuits will measure approximately 6.5V DC. Ground for the CD changer id provided at G104.
Radio/Navigation System Schematics
Radio/Audio System Description and Operation
Control Module References for scan tool information
Radio ON, verify the CD changer operates properly and audio can be heard from the speakers.
⇒ | If the CD changer operates properly and audio is inoperative or distorted from one or all of the speakers, refer to Speaker Malfunction . |
⇒ | If greater than the specified range, test the ground circuit for an open/high resistance. |
⇒ | If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance. |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.