GM Service Manual Online
For 1990-2009 cars only
Table 1: Steering Column Lock Module Scan Tool Data Parameters
Table 2: Steering Column Lock Module Scan Tool Output Controls

Steering Column Lock Module Scan Tool Data Parameters

Parameter

System State

Expected Value

Description

Operating Conditions: Engine ON

Battery Voltage Signal

--

Varies

This displays Volts. This is the current battery voltage signal.

Column Feedback Signal

--

Varies

This displays Volts. This is the current column feedback signal.

Column Lock Enable Signal

--

Disabled

The scan tool displays Enabled or Disabled. This is the state of the column lock enable signal.

Column Lock Module Status

--

Disabled

The scan tool displays Enabled or Disabled. This is the state of the column lock module.

Column Lock Motor Command

--

Idle

The scan tool displays Idle, Unlock, Lock or Invalid. This is the state of the column lock motor command.

Column Lock Motor Status

--

Idle

The scan tool displays Idle, Unlock, Lock or Invalid. This is the state of the column lock motor.

Column Lock Status

--

Unlocked

The scan tool displays Locked, Unlocked, Unlk Volt Delay, Column Unlocking, Unlock Failure, Column Locking, Locking Failure, Lock Fail Unlk, Lock Fail Stdby, Unlk Batt Reconn, Batt Reconnected, Disabled Unlk., Fail Enable Lock, Fail Enab. Latch, Fail Enab. Unlk., Fail Enab. Stdby, Config. Conflict or Override Disable. This is the state of the column lock.

Ignition Voltage Signal

--

Varies

This displays Volts. This is the current state of the ignition voltage signal.

Park Switch

--

On

The scan tool displays On or Off. This is the state of the park switch.

Password Status

--

Valid

The scan tool displays Valid, Invalid or Not Programmed.

Steering Column Lock Module Scan Tool Output Controls

Scan Tool Output Control

Description

Column Lock

The steering column lock module can be commanded by using the scan tool to energize the column lock enable circuit.

Column Unlock

The steering column lock module can be commanded by using the scan tool to energize the column unlock enable circuit.