GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2008 🢒 XLR 🢒 Power and Signal Distribution 🢒 Data Communications 🢒 Remote Control Door Lock Receiver Replacement

Removal Procedure
  1. Turn the ignition to OFF.
  2. Remove the instrument panel (I/P) trim pad. Refer to Instrument Panel Trim Pad Replacement.

    3. Object Number: 1231031 Size: SH
  3. Remove the retaining screws from the remote control door lock receiver.
  4. Remove the receiver from the I/P carrier in order to access the wire harness connection.
  5. Disconnect the wire harness connector from the door lock receiver.
  6. Remove the door lock receiver.

Installation Procedure

    Object Number: 1231031 Size: SH
  1. Connect the receiver connector and route the wire harness through the I/P carrier.
  2. Line up the receiver with the hole on the retainer.

    3. Notice: Refer to Fastener Notice in the Preface section.

  3. Install the retaining screws to the remote control door lock receiver.

    4. Tighten
    Tighten the screws to 2.5 N·m (22 lb in).

  4. Install the I/P trim pad. Refer to Instrument Panel Trim Pad Replacement.
  5. Perform the RCDLR programming and setup procedure. Refer to Control Module References for programming and setup information.