GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

    Caution: Refer to SIR Caution in the Preface section.

    Caution: Do not strike or jolt the inflatable restraint sensing and diagnostic module (SDM). Before applying power to the SDM, make sure that it is securely fastened with the arrow facing toward the front of the vehicle. Failure to observe the correct installation procedure could cause SIR deployment, personal injury, or unnecessary SIR system repairs.

  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. Remove the accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement .

  3. Object Number: 391030  Size: SH
  4. Remove the connector position assurance (CPA) from the SDM harness connector.
  5. Disconnect the SDM harness connector.

  6. Object Number: 1226211  Size: SH
  7. Remove the SDM mounting fasteners.
  8. Remove the SDM from the I/P center support system.

Installation Procedure

  1. Remove any dirt, grease, or other impurities from the mounting surface.

  2. Object Number: 1226211  Size: SH
  3. Install the SDM horizontally to the I/P center support system.
  4. Point the arrow on the SDM toward the front of the vehicle.
  5. Notice: Refer to Fastener Notice in the Preface section.

  6. Install the SDM mounting fasteners.
  7. Tighten
    Tighten the fasteners to 10 N·m (89 lb in).

  8. Install the SDM harness connector to the SDM.

  9. Object Number: 391030  Size: SH
  10. Install the CPA to the SDM harness connector.
  11. Install the accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement .
  12. Important: The AIR BAG indicator may remain ON after the SDM has been replaced. DTC B1001 may set requiring the SDM part number to be set in multiple modules. If the indicator remains ON after enabling the SIR system, perform the diagnostic system check and follow the steps thoroughly to ensure that the SDM is set properly.

  13. Enable the SIR system. Refer to SIR Disabling and Enabling .
  14. Refer to Control Module References for programming and setup information.