Tools Required
J 39400-A
Halogen Leak Detector
Removal Procedure
- Recover the refrigerant. Refer to
Refrigerant Recovery and Recharging
.
- Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle
.
- Remove the right front wheel and tire from the vehicle. Refer to
Tire and Wheel Removal and Installation
.
- Disconnect the RH ESC position sensor harness connector.
- Disconnect the ESC sensor link from the control arm link stud.
- Remove the ESC position sensor mounting bolt.
- Remove the ESC position sensor from the vehicle.
- Disconnect the front RH ABS electrical connector from the engine cradle and reposition aside.
Important: Cap or tape the open A/C components immediately to prevent system contamination.
- Remove the high pressure relief valve.
- Cap or tape the A/C compressor.
Installation Procedure
- Remove the cap or tape from the A/C compressor.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the high pressure relief valve.
Tighten
Tighten the valve to 8 N·m (70 lb in).
- Connect the front RH ABS electrical connector to the engine cradle.
- Install the ESC position sensor to the vehicle.
- Install the ESC position sensor mounting bolt.
Tighten
Tighten the bolt to 3 N·m (26 lb in).
- Connect the ESC sensor link to the control arm link stud.
- Connect the RH ESC position sensor harness connector.
- Install the right front wheel and tire to the vehicle. Refer to
Tire and Wheel Removal and Installation
.
- Lower the vehicle.
- Evacuate and recharge the refrigerant system. Refer to
Refrigerant Recovery and Recharging
.
- Leak test the fittings of the component using
J 39400-A
.