Tools Required
J 43244 Relay Puller Pliers
Removal Procedure
- Remove the electrical center cover.
- Locate the compressor relay. Refer to
Electrical Center Identification Views
to locate the electrical center where the
compressor relay exists.
Important:
• | Always note the orientation of the relay. |
• | Make sure the electrical center is secure, as not to put added stress
on the wires or terminals. |
- Using the J 43244
(1) position the tool on opposing corners of the compressor
relay (2).
Notice: Use J43244 to pull the relay straight out from the electrical
center terminals. The use of pliers or a flat bladed tool could damage the
electrical center.
- Remove the compressor relay (2) from the electrical center.
Installation Procedure
- Install the compressor relay (2)
in the same position as removed.
- Install the electrical center cover.