Removal Procedure
Caution: Refer to Brake Fluid Irritant Caution in the Preface section.
Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice in the Preface section.
- Inspect the fluid level in the brake master cylinder reservoir.
- If the brake fluid level is midway between the maximum-full point and the minimum allowable level, no brake fluid needs to be removed from the reservoir before proceeding.
- If the brake fluid level is higher than midway between the maximum-full point and the minimum allowable level, remove brake fluid to the midway point before proceeding.
- Raise and suitably support the vehicle. Refer to
Lifting and Jacking the Vehicle
.
- Remove the tire and wheel assembly. Refer to
Tire and Wheel Removal and Installation
.
- Remove the brake caliper inlet fitting bolt from the caliper.
- Remove the brake hose from the brake caliper.
- Remove and discard the two copper brake hose gaskets. These gaskets may be stuck to the brake caliper and/or the brake hose end.
- Plug the opening in the brake caliper and the brake hose to prevent fluid loss and contamination.
- Remove the brake caliper guide pin bolts.
- Remove the brake caliper from the caliper mounting bracket.
Installation Procedure
- Inspect the caliper slide boots for cuts, tears, or deterioration. If damaged, replace the slides and the boots. Refer to
Front Disc Brake Hardware Replacement
.
- Install the brake caliper to the caliper mounting bracket.
Notice: Refer to Fastener Notice in the Preface section.
- Install the brake caliper guide pin bolts.
Tighten
Tighten the brake caliper guide pin bolts to 31 N·m (23 lb ft).
- Remove the plug from the brake caliper opening and the brake hose.
Important: Install NEW copper brake hose gaskets.
- Assemble the NEW copper brake hose gaskets, and the brake caliper inlet fitting bolt to the brake hose.
- Install the brake hose and the brake caliper inlet fitting bolt to the brake caliper.
Tighten
Tighten the brake caliper inlet fitting bolt to 45 N·m (33 lb ft).
- Bleed the hydraulic brake system. Refer to
Hydraulic Brake System Bleeding
.
- Install the tire and wheel assembly. Refer to
Tire and Wheel Removal and Installation
.
- Lower the vehicle.