GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2008 🢒 XLR 🢒 General Information 🢒 General Information 🢒 Brake Pressure Modulator Valve Bracket Replacement

Removal Procedure

    Important: 

       • The ignition mode switch has 2 contact buttons.
       • The upper button, with a circle indicator on it, starts the engine if the brake pedal is applied.
       • The lower button has 2 indicators on it, O and ACC. This button cycles the ignition through the following modes:
          - OFF- This is the normal state upon entering the vehicle. and can also be reached from any other mode by depressing the button. The O indicator illuminates.
          - Accessory -This mode can be reached from the OFF state by depressing the button. The ACC indicator illuminates.
          - On with the engine OFF-This state can be reached from the OFF or Accessory modes by depressing the button for about 5-6 seconds. The upper LED illuminates.

  1. Turn the ignition switch to the OFF position.
  2. Remove the brake pressure modulator valve (BPMV). Refer to Brake Pressure Modulator Valve Replacement .
  3. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .

    4. Object Number: 692288 Size: SH
  4. Remove the BPMV bracket bolts.
  5. Remove the steering gear nut and bolt.
  6. Remove the BPMV bracket.

Installation Procedure

    Object Number: 692288 Size: SH
  1. Install the EBCM/BPMV bracket to the crossmember.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the bracket bolts to the EBCM/BPMV bracket.

    3. Tighten
    Tighten the bolts to 27 N·m (20 lb ft).

  3. Install the steering gear bolt and nut.

    4. Tighten
    Tighten the nut to 100 N·m (74 lb ft).

  4. Install the EBCM/BPMV assembly into the bracket.