Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC B3122: Keyless Entry Antenna 4 PerformanceDiagnostic Fault Information
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
Keyless Entry Antenna - Left Signal | B3119 | B3119 | B3119 | -- |
Keyless Entry Antenna - Right Signal | B3120 | B3120 | B3120 | -- |
Keyless Entry Antenna - Rear Compartment Signal | B3121 | B3121 | B3121 | -- |
Keyless Entry Antenna - Back Up Signal | B3122 | B3122 | B3122 | -- |
Keyless Entry Antenna - Left Low Reference | -- | B3119 | B3119 | -- |
Keyless Entry Antenna - Right Low Reference | -- | B3120 | B3120 | -- |
Keyless Entry Antenna - Rear Compartment Low Reference | -- | B3121 | B3121 | -- |
Keyless Entry Antenna - Back Up Low Reference | -- | B3122 | B3122 | -- |
Circuit/System Description
The back up keyless entry antenna is located in the glove compartment area and is used as a short range low frequency (LF) transmitter. When a valid key fob is within the passenger compartment and the brake pedal is depressed and the ignition button is pressed the keyless entry antenna transmitter broadcasts a challenge within the passenger compartment to the key fob. If the response from the key fob via radio frequency (RF) is a valid response and all the security requirement are met the vehicles engine will start or be able to go into accessory mode.
Conditions for Running the DTC
A transmitter validation is requested.
Conditions for Setting the DTC
An improper voltage level is seen on the keyless entry antenna - back up signal circuit.
Action Taken When the DTC Sets
The back up keyless entry antenna is ignored.
Conditions for Clearing the DTC
| • | A current DTC will clear when the conditions for setting the DTC are no longer present. |
| • | A history DTC will clear after 50 malfunction free ignition cycles. |
Reference Information
Schematic Reference
Connector End View Reference
Description and Operation
Keyless Entry System Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for Scan Tool Information
Circuit/System Testing
- Ignition OFF, disconnect the harness connector at the back up keyless entry antenna.
- Ignition ON, verify a test lamp does not illuminate between the signal circuit terminal A and ground.
- Ignition OFF, install a DMM between the signal circuit terminal A and the low reference circuit terminal B. Set the DMM to capture AC voltage using the MIN MAX function.
- Ignition ON, verify the DMM captured an AC voltage signal.
- If all circuits test normal, test or replace the back up keyless entry antenna.
| ⇒ | If the test lamp illuminates, test the signal circuit for a short to voltage. If the circuit tests normal, replace the RCDLR. |
| ⇒ | If an AC voltage was not captured, test the signal circuit and the low reference circuit for a short to ground or an open/high resistance. If the circuits test normal, replace the RCDLR. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
| • | Control Module References for RCDLR replacement, setup, and programming |
