For 1990-2009 cars only
Removal Procedure
- Remove the drive belt. Refer to Drive Belt Replacement .
- Remove the power steering reservoir. Refer to Power Steering Fluid Reservoir Replacement .
- Install a wrench on the accessory drive belt tensioner (3).
- Rotate the wrench to release tension.
- With the tension applied, remove the belt from the power steering pulley.
- Remove the top bolt (1) from the accessory drive belt tensioner.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove bottom bolt (2) from the accessory drive belt tensioner damper.
- Remove the tensioner.
Installation Procedure
- Install the accessory drive belt tensioner.
- Tighten the accessory drive belt tensioner bolts (1, 2) to 25 N·m (18 lb ft) .
- Lower the vehicle.
- Attach a wrench to the tensioner.
- Rotate the wrench to release the tension and feed belt around the power steering pulley.
- With the tension applied, complete the belt routing. Ensure the belt is properly seated in all pulleys.
- Slowly return the tensioner back to its original position. This will apply tension to the drive belt.
- Remove the wrench.
- Install the power steering reservoir. Refer to Power Steering Fluid Reservoir Replacement .
- Install the drive belt. Refer to Drive Belt Replacement .
- Start the engine and inspect for proper belt and accessory operation.
Caution: Refer to Fastener Caution in the Preface section.
