Special Tools

J 7872 Magnetic Base Dial Indicator

For equivalent regional tools, refer to Special Tools

1. Clean the camshaft in solvent.

Warning: Refer to Safety Glasses Warning in the Preface section.

2. Dry the camshaft with compressed air.
3. Cover the camshafts with a clean oil soaked towel in order to prevent corrosion.

1. Inspect the camshaft sprocket locating pin (2) for damage or wear.
2. Inspect the threads (3) for the camshaft sprocket bolt.
3. Inspect the camshaft lobes (1) and journals (4) for the following conditions:

•	Excessive scoring or pitting

•	Discoloration from overheating

•	Deformation from excessive wear, especially the camshaft lobes

1. With the camshaft in a suitable fixture, measure the camshaft for wear.



2. Measure the camshaft journals for diameter and out-of-round using an outside micrometer.

•	If the diameter is smaller than 26.948 mm (1.061 in), replace the camshaft.

•	If the out-of-round exceeds 0.022 mm (0.0009 in), replace the camshaft.




3. Measure the camshaft runout using J 7872 indicator . Refer to Engine Mechanical Specifications.



4. Measure the camshaft thrust wall width (1) for wear using an inside micrometer. Refer to Engine Mechanical Specifications.
5. Measure the camshaft thrust wall surface (2) for runout using J 7872 indicator . Refer to Engine Mechanical Specifications.
6. If the camshaft is damaged or worn beyond specifications, replace the camshaft. No machining of the camshaft is allowed.



7. Measure the camshaft lobes for wear using the J 7872 indicator .



8. Place the J 7872 indicator with the indicator tip on the base circle (2) of the camshaft lobe.

8.1.	Place the J 7872 indicator dial at zero.

8.2.	Rotate the camshaft until the indicator tip is at the highest point on the lobe. This reading is the lift (1) of the camshaft lobe.

8.3.	The specifications for lift are as follows:

•	Intake camshaft: 6.166 mm (0.2428 in)

•	Exhaust camshaft: 5.944 mm (0.2336 in)

9. If the indicated measurement is significantly lower than these specifications, replace the camshaft or engine performance will be reduced.