For 1990-2009 cars only
- Position the generator rear brace to the engine.
- Install the generator rear brace bolt finger tight.
- Install the generator/drive belt idler pulley mounting stud and tighten to 12 N·m (118 lb in).
- Install the generator over the generator/drive belt idler pulley mounting stud.
- Install the upper front generator bolt finger tight through the generator and into the rear generator brace.
- Install the drive belt idler pulley and bracket over the generator/drive belt idler pulley stud and the drive belt idler pulley bolt through the generator.
- Install the nut on the generator/drive belt idler pulley mounting stud.
- Tighten the generator and drive belt idler pulley bolts and nut in the sequence shown.
- Tighten the rear generator brace bolt. Tighten the rear generator brace bolt (1) to 50 N·m (37 lb ft).
- Install the NEW generator coolant hose sealing rings.
- Install the hose into the fitting in the engine front cover.
- Install the cooling hose assembly onto the generator port.
- Install the bolt through the cooling hose assembly into the generator and tighten to 27 N·m (19 lb ft).
Caution: Refer to Fastener Caution in the Preface section.
| 8.1. | Tighten the front upper generator bolt (1) to 50 N·m (37 lb ft). |
| 8.2. | Tighten the generator/drive belt idler pulley stud nut (2) to 50 N·m (37 lb ft). |
| 8.3. | Tighten the drive belt idler pulley bolt (3) to 50 N·m (37 lb ft). |
