Special Tools

J 38185 Hose Clamp Pliers

1. Drain the cooling system. Refer to Cooling System Draining and Filling.
2. Remove the air outlet duct in order to gain access to the thermostat housing. Refer to Air Cleaner Inlet Duct Replacement.
3. Remove the heater hose from the thermostat housing using a J 38185 .
4. Remove the coolant radiator hose from the thermostat housing. Refer to Coolant Bypass Hose Replacement.
5. Remove the drive belt tensioner. Refer to Drive Belt Tensioner Replacement.
6. Remove the accessory drive belt. Refer to Drive Belt Replacement.



7. Remove the drive belt idler pulley bolt.

Remove the drive belt idler pulley.




8. Remove the water pump pulley.
9. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
10. Remove the crankshaft balancer. Refer to Crankshaft Balancer Replacement.



11. Remove the engine front cover bolts.
12. Remove the engine front cover.



13. Remove and discard the engine front cover gasket.

Clean and inspect the engine front cover. Refer to Engine Front Cover Cleaning and Inspection.

1. Place a small amount of sealant at the split line of the upper and lower crankcases (1), and at the top of the block face. Refer to Adhesives, Fluids, Lubricants, and Sealers for the correct part number.



2. Place the NEW engine front cover gasket over the crankcase dowel pins.



3. Place the engine front cover in position on the crankcase.
4. Apply the thread locking compound to the threads of the engine front cover bolts. Refer to Adhesives, Fluids, Lubricants, and Sealers for the correct part number.
5. Install the engine front cover retaining bolts.

Caution: Refer to Fastener Caution in the Preface section.




6. Tighten the engine front cover bolts in the sequence shown to 15 N·m (11 lb ft).
7. Install the crankshaft balancer. Refer to Crankshaft Balancer Replacement.
8. Install the water pump pulley and tighten to 10 N·m (89 lb in).



9. Install the drive belt idler pulley.
10. Install the drive belt idler pulley bolt and tighten to 50 N·m (37 lb ft).
11. Install the accessory drive belt. Refer to Drive Belt Replacement.
12. Install the drive belt tensioner. Refer to Drive Belt Tensioner Replacement.
13. Install the coolant radiator hose to the thermostat housing. Refer to Coolant Bypass Hose Replacement.
14. Install the heater hose to the thermostat housing using a J 38185 .
15. Install the air outlet duct. Refer to Air Cleaner Inlet Duct Replacement.
16. Fill the cooling system. Refer to Cooling System Draining and Filling.