GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2009 🢒 XLR 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Folding Top Stowage Compartment Front Closeout Panel Position Switch Replacement

Removal Procedure

    Object Number: 1294372 Size: SH
  1. Place the folding top in the up position.
  2. Open the rear compartment.

    3. Object Number: 1274144 Size: SH
  3. Lower the rear compartment partition (1).
  4. Place a protective covering over the interior and the adjacent body panels.
  5. Locate the hydraulic pump beneath the carpet in the storage compartment on the driver side of the trunk.

    6. Object Number: 1274131 Size: SH
  6. Turn the bypass valve (1) counterclockwise until the valve stops.
  7. Lower the closeout screen.

    8. Object Number: 1235018 Size: SH
  8. Locate the position switch (1).

    9. Object Number: 1237027 Size: SH
  9. Release the electrical connector (1) from the link.
  10. Disconnect the position switch electrical connector (1).

    11. Object Number: 1237028 Size: SH
  11. Remove the position switch screw (1).
  12. Remove the position switch (3) from the link (2).

Installation Procedure

    Object Number: 1235019 Size: SH
  1. The position switch service kit contains one position switch (2) and 3 electrical connector retainer clips (1). Find and install the retainer clip that matches the clip on the position switch that you are replacing.

    2. Object Number: 1237033 Size: SH
  2. Position the position switch (1) to the link (3). Align the D-shaped rotor into the D-shaped hole (4) in the link.
  3. Rotate the position switch until the screw holes (2) are aligned.

    4. Object Number: 1237028 Size: SH
  4. Apply LOCTITE™ Blue, GM P/N 12345382 (Canadian P/N 10953489) or equivalent to the bolts.

    5. Caution: Refer to Fastener Caution in the Preface section.

  5. Install the position switch screw (1) and tighten to 3.5 N·m (31 lb in).

    6. Object Number: 1237027 Size: SH
  6. Connect the position switch electrical connector (1).
  7. Clip the electrical connector to the link in the original location.
  8. Install the closeout screen.

    9. Object Number: 1274131 Size: SH
  9. Turn the pump bypass valve (1) clockwise until the valve stops.
  10. Remove the protective covering.

    11. Object Number: 1274144 Size: SH
  11. Raise the rear compartment partition (1).
  12. Close the rear compartment.
  13. Operate the folding top under power through one complete cycle in each direction.
  14. Inspect the folding top for proper operation. Refer to Power Folding Top Description and Operation.