GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2009 🢒 XLR 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Door Lock Switch Replacement - Driver Door

Removal Procedure

    Note: When removing the power door lock switch, place the ignition switch in the OFF position.

  1. Remove the door trim panel. Refer to Door Trim Panel Replacement.
  2. Remove the retainer screws from the back of the upper trim panel.
  3. Remove the upper trim from the door.

    4. Object Number: 1272532 Size: SH
  4. Remove the inner energy absorber from the door panel.
  5. Remove 4 retaining screws from the rear of the armrest.
  6. Remove 1 retaining screw from the forward end of the armrest assembly.

    7. Object Number: 1271088 Size: SH
  7. Disconnect the armrest wire harness and remove the armrest assembly.

    8. Object Number: 1271255 Size: SH

    Note: Use care when removing the power window switch assembly, because the mirror, the window, and the applique to the door lock switch plate can be easily damaged. Apply duct tape to protect the finish.

  8. Remove the power door lock switch assembly from the pocket in the door trim panel.
  9. Disconnect the wire harness to the power door lock switch.

    10. Object Number: 1271233 Size: SH
  10. Remove the power door lock switch from the armrest switch plate applique.

Installation Procedure

    Object Number: 1271233 Size: SH
  1. Install the power door lock switch to the armrest switch plate applique. Push to engage the switch to the applique.
  2. Connect the wire harness to the door lock switch assembly.

    3. Object Number: 1271255 Size: SH
  3. Install the lock switch assembly into the pocket in the door trim panel.
  4. Remove any protective tape.

    5. Object Number: 1271088 Size: SH
  5. Connect the wire harness to the door armrest assembly.

    6. Caution: Refer to Fastener Caution in the Preface section.

  6. Install the armrest to the door trim panel. Secure the armrest with 4 retaining screws at the rear and 1 screw at the forward end of the armrest assembly. Tighten the screws to 10 N·m (89 lb in).

    7. Object Number: 1272532 Size: SH
  7. Install the inner energy absorber to the door panel.
  8. Install the upper trim to the door.
  9. Install the retainers at the back of the door trim panel and tighten to 10 N·m (89 lb in).
  10. Install the door trim panel. Refer to Door Trim Panel Replacement.