For 1990-2009 cars only
Removal Procedure
- Turn OFF the ignition switch.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
- Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
- Disconnect the electronic suspension control (ESC) position sensor harness connector.
- Disconnect the position sensor link from the control arm link stud.
- Remove the position sensor mounting bolt.
- Remove the position sensor from the vehicle.
Installation Procedure
- Install the position sensor to the vehicle.
- Install the position sensor mounting bolt and tighten to 7 N·m (62 lb in).
- Connect the position sensor link to the control arm link stud.
- Connect the ESC position harness connector.
- Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
- Lower the vehicle.
Caution: Refer to Fastener Caution in the Preface section.
