GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2009 🢒 XLR 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Accelerator Pedal Position Sensor Replacement

Removal Procedure

    Caution: Handle the electronic throttle control components carefully. Use cleanliness in order to prevent damage. Do not drop the electronic throttle control components. Do not roughly handle the electronic throttle control components. Do not immerse the electronic throttle control components in cleaning solvents of any type.

  1. Remove the left instrument panel (I/P) on the lower closeout insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .

    2. Object Number: 1252542 Size: SH
  2. Disconnect the electrical connector (1) from the accelerator pedal sensor module .

    3. Object Number: 931700 Size: SH
  3. Remove the accelerator pedal mounting bolts (1).
  4. Remove the accelerator pedal (2).

Installation Procedure

    Object Number: 931700 Size: SH
  1. Install the accelerator pedal to the steering column support bracket.

    2. Caution: Refer to Fastener Caution in the Preface section.

    Note: Always use a torque wrench in order to obtain the proper torque.

  2. Install the accelerator pedal mounting bolts (1) and tighten to 10 N·m (89 lb in) .

    3. Object Number: 1252542 Size: SH
  3. Connect the accelerator pedal sensor module electrical connector (1).
  4. Check for correct carpet fit under the accelerator pedal.
  5. Install the left I/P on the lower closeout insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .