Brake Pedal Position Sensor Replacement for Cadillac XLR 2009

1. Remove the instrument panel (I/P) insulator. Refer to Instrument Panel Insulator Panel Replacement - Left Side.
2. Disengage but do not remove the connector position assurance (CPA) on the connector.

Disconnect the electrical connector (2).




3. Remove the screw and discard.
4. Remove the brake pedal position sensor and discard.

Note: Do NOT reuse the sensor or bolt. Always use a NEW sensor and bolt.

1. Install a NEW sensor.
2. Position the sensor fork to the pin.
3. Rotate the sensor in order to align the sensor locator to the hole in the extension bracket.

Caution: Refer to Fastener Caution in the Preface section.

4. Install a NEW brake pedal position sensor screw and tighten to 2 N·m (18 lb in).



5. Connect the electrical connector (2).

Engage the CPA. The CPA will not engage if the connector is not attached properly.

6. Calibrate the sensor. Refer to Brake Pedal Position Sensor Calibration.
7. Install the I/P insulator. Refer to Instrument Panel Insulator Panel Replacement - Left Side.