For 1990-2009 cars only
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC C0245 00: Wheel Speed Sensor FrequencyCircuit/System Description
The wheel speed sensor receives ignition voltage from the electronic brake control module (EBCM) and provides an output signal to the EBCM. As the wheel spins, the wheel speed sensor sends the EBCM a DC square wave signal, and uses the frequency of the square wave signal to calculate the wheel speed.
Conditions for Running the DTC
| • | Ignition voltage is greater than 10 volts. |
| • | No wheel speed sensor faults exist. |
| • | Brake is not applied. |
| • | Vehicle is not cornering. |
Conditions for Setting the DTC
Wheel speed differences between one wheel and the others is greater than 5 percent.
Action Taken When the DTC Sets
| • | The EBCM disables the traction control system (TCS) and vehicle stability enhancement system (VSES) for the duration of the ignition cycle. |
| • | A DIC message and/or a warning indicator may be displayed. |
Conditions for Clearing the DTC
| • | The condition for setting the DTC is no longer present. |
| • | The EBCM clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles. |
Reference Information
Schematic Reference
Antilock Brake System Schematics
Connector End View Reference
Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
Inspect for one tire that has improper air pressure or improper size.
