For 1990-2009 cars only
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC C0550 00: Electronic Control Unit (ECU) PerformanceCircuit/System Description
The electronic brake control module (EBCM) detects an internal malfunction.
Conditions for Running the DTC
The ignition switch is in the ON position.
Conditions for Setting the DTC
An internal EBCM malfunction exists.
Action Taken When the DTC Sets
One or more of the following actions may occur:
| • | The EBCM disables the antilock brake system (ABS). |
| • | The EBCM disables or degrades the dynamic rear proportioning (DRP) function. |
| • | A DIC message and/or a warning message may be displayed |
Conditions for Clearing the DTC
| • | The condition for setting the DTC is no longer present. |
| • | The EBCM automatically clears a history DTC when a current DTC is not detected in 100 consecutive drive cycles. |
Reference Information
Schematic Reference
Antilock Brake System Schematics
Connector End View Reference
Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for Scan Tool Information
Circuit/System Verification
Verify DTC C0550 is not a current DTC.
| ⇒ | If DTC C0550 is current, replace the EBCM. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for EBCM replacement, setup, and programming
