For 1990-2009 cars only
Removal Procedure
- Remove the rear brake rotor. Refer to Rear Brake Rotor Replacement.
- Rotate the park brake adjuster nut until the bolt is in the closed position.
- Remove the park brake shoe retaining spring.
- Remove the park brake shoe assembly by grasping the shoe and spreading slightly while pulling the shoe from the actuator assembly.
- Remove the two actuator mounting bolts.
- Remove the actuator assembly from the dust shield.
Installation Procedure
- Apply high temperature, silicone lubricant to positions 1 and 2. Do not apply grease to the bolt threads (3).
- Install the actuator to the dust shield.
- Apply high temperature, silicone lubricant to the brake caliper bolt shaft. Do not lubricate the bolt threads.
- Install the actuator mounting bolts and tighten to 70 N·m (52 lb ft).
- Install the park brake shoe assembly by grasping the shoe and spreading slightly while pulling the shoe over the actuator assembly.
- Install the park brake shoe retaining spring.
- Adjust the park brake. Refer to Park Brake Adjustment.
- Install the brake rotor. Refer to Rear Brake Rotor Replacement.
Caution: Refer to Fastener Caution in the Preface section.
