For 1990-2009 cars only
Removal Procedure
- Ensure that the park brake is in the full returned position.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
- Remove the rear tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation.
- Disconnect the rear park brake cables from the left and right park brake actuators.
- Remove the LH lower closeout panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side.
- Remove the instrument panel cluster (IPC). Refer to Instrument Cluster Replacement.
- Remove the park brake assembly attaching nuts (1) and bolt (2).
- Disconnect the park brake switch electrical connector.
- Disconnect the park brake release solenoid electrical connector.
- Rotate the park brake actuator cable tensioning spring (1) and secure.
- Disconnect the front park brake cable from the pedal assembly.
- Remove the park brake pedal assembly.
Installation Procedure
- Install the front park brake cable into the park brake pedal assembly.
- Install the park brake pedal assembly retaining nuts and bolt and tighten to 10 N·m (89 lb in).
- Connect the park brake release solenoid electrical connector.
- Connect the park brake switch electrical connector.
- Raise the vehicle.
- Connect the rear cables to the left and right park brake actuators.
- Install the rear tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation.
- Lower the vehicle.
- Release tension from the cable tensioning spring.
- Install the IPC. Refer to Instrument Cluster Replacement.
- Install the LH lower closeout panel.
- Apply the park brake pedal and release 2-3 times, to assure proper function of the park brake system.
Caution: Refer to Fastener Caution in the Preface section.
