GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2009 🢒 XLR 🢒 Body Hardware and Trim 🢒 Interior Trim and Paneling 🢒 Front Side Door Window Switch Bezel Replacement

Removal Procedure
  1. Remove the door trim panel. Refer to Door Trim Panel Replacement.
  2. Remove the retainer screws from the back of the door trim panel.
  3. Remove the upper trim from the door.

    4. Object Number: 1272532 Size: SH
  4. Remove the energy absorber from the door panel.
  5. Remove the 4 retaining screws from the rear of the armrest and 1 screw from the forward end of the armrest assembly.

    6. Object Number: 1271088 Size: SH
  6. Disconnect the electrical connector and remove the armrest assembly.

    7. Object Number: 1270905 Size: SH

    Note: Use care when removing and installing the switch bezel assembly, because the bezel is easily damaged. Prior to removal, apply duct tape to protect the finish.

  7. Remove the front door switch assembly from the pocket in the door trim panel.
  8. Disconnect the door switch electrical connector.

    9. Object Number: 1271233 Size: SH
  9. Remove the door switch assemblies from the door switch bezel.

Installation Procedure

    Object Number: 1271233 Size: SH
  1. Install the door switch assemblies to the door switch bezel. Push to engage the switch to the bezel.
  2. Connect the door switch electrical connector.

    3. Object Number: 1270905 Size: SH
  3. Install the front door switch assembly to the pocket in the door trim panel.
  4. Remove any protective tape prior to installation of the armrest.

    5. Object Number: 1271088 Size: SH
  5. Connect the electrical connector to the armrest assembly.
  6. Install the 4 retaining screws to the rear of the armrest and 1 screw to the forward end of the armrest assembly.

    7. Object Number: 1272532 Size: SH
  7. Install the energy absorber to the door panel.
  8. Install the upper trim to the door.

    9. Caution: Refer to Fastener Caution in the Preface section.

  9. Install the retainer screws to the back of the door trim panel.

    10. Tighten
    Tighten the screws to 4 N·m (35 lb in).

  10. Install the door trim panel. Refer to Door Trim Panel Replacement.