REAR WHEEL SPIN ON ICE REDUCE COLD IDLE AS OUTLINED

MODELS: 1985-86 SAFARI/ASTRO VANS WITH 4.3L ENGINE AND AUTOMATIC TRANSMISSION

Some customers may experience a condition immediately after cold vehicle startup where, by applying the brake pedal, they are unable to completely stop the rear wheels from turning on icy surfaces.

Variables such as rear axle ratios and higher engine rpm while the vehicle is in the cold idle mode can result in inereased torque to the rear wheels. These variables, in conjunction with a lightly loaded rear axle, can increase the pedal effort required to stop the rear wheels from spinning on ice when the vehicle is placed in gear. This condidon can be effectively addressed by using the foflowing procedure to reduce the cold idle speed of the engine.

NOTE: Separate procedures to reduce engine cold idle speed apply to each model year.

1985 MODEL 4.3L CARBURETED ENGINE

Reduce cold idle speed to 1600 rpm.

1. Remove dash extension. 2. Remove engine cover. 3. Install tachometer. The tachometer (tach) terminal is next to the engine control switch (bat) connector on the distributor cap (Reference Figure No. 1).

NOTE: The tachometer terminal must never be allowed to touch ground, because damage to the module inside the distributor and/or ignifion coil can result

4. Reduce cold idle speed to 1600 rpm by adjusting the fast idle screw. Refer to tune up label for procedure. 5. Remove tachometer and reinstall engine cover and dash extension. 6. On a clean dry surface, next to the existing tune up label located on the fan shroud, place label P/N 10066488.

1986 MODEL 4.3L TBI ENGINES

The cold engine idle speed of the 1986 models is to be reduced by the replacement of the PROM, reference Figure No. 2.

1986 model vehicies built before VINS listed below require PROM replacement.

GMC GB524481 Federal Emissions GB524599 California Emissions Chevrolet GB203188 Federal Emissions GB203623 California Emissions

Vehicles built after these VIN breakpoints have the recalibrated PROM factory installed.

NOTE: Any time the PROM is installed backwards and the ignition switch turned on, the PROM is destroyed and must be replaced.

1. Disconnect negative battery cable. 2. Remove kick panel from right side of the vehicle (1 screw) interior. 3. Remove ECM (2 screws). 4. Disconnect electrical harnesses from ECM module. 5. Remove ECM cover (2 screws). 6. Remove PROM from ECM and replace with new PROM, P/N 16068877 (Federal), P/N 16068926 (California). 7. Replace ECM cover. 8. Reconnect electrical harness. 9. Secure ECM module to its mounting location. 10. Replace kick panel.

PARTS LIST

Label (1985 Model Only) P/N 10066488 PROM Federal/High Altitude P/N 16068877 Emissions PROM Calfornia Emissions P/N 16068926

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.