SEATBELT STOP BUTTON BREAKS (INSTALL NEW STOP BUTTON KIT)

SUBJECT: SEAT BELT STOP BUTTON BREAKS (INSTALL REPLACEMENT STOP BUTTON KIT)

VEHICLES AFFECTED: 1992-93 "M/L" VANS

THIS BULLETIN IS BEING REVISED TO INCLUDE THE INTERMEDIATE AND REARSEAT LAP-SHOULDER BELT STOP BUTTONS.

Some owners of 1992-93 M/L vans may comment that the lap-shoulder seatbelt stop button used on the outboard seat positions of the driver, passenger, intermediate and rear seat (if applicable), has broken or fallen off.

This condition may be corrected by installing a replacement stop button kit which is now available from GMSPO under the part numbers listed in the SERVICE PARTS INFORMATION section of this bulletin. The kit contains two sets of the two piece buttons.

SERVICE PROCEDURE

(For front passenger or driver seat position)

1. Extend the belt out as far as possible from the retractor assembly which is located at the base of the "B" pillar.

2. Find the centre width measurement that is approximately 26 in. (66 cm) from the seam of the belt which attaches the anchor plate to the retractor assembly (Figure 1).

(For intermediate and rear seat position)

3. Find the center width measurement that is approximately 6 in. (1 5 cm) from the seam of the belt which attaches the seat or retractor assembly (Figure 2 & 3).

4. Position the latch plate ABOVE the location of the stop button (Figure 1).

5. Insert the pin half of the button into the seat belt webbing at the location measured in step 2 and align the other button half to the pin portion.

6. Press the two halves together with your fingers or a pair of pliers.

SERVICE PARTS INFORMATION

Part Number Description ----------- ------------- 12540460 Button Asm (gray) 12540461 Button Asm (blue) 12540462 Button Asm (red) 12540463 Button Asm (beige)

For vehicles repaired under warranty use:

Labour Time 0.2 hrs./veh

Seat Belt Stop Buttons - Replace 0.2 hrs./veh

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.