Evaporative Emission Pipe for Chevrolet Astro - 2WD 1996

The EVAP pipe is secured to the underbody with clamp and screw assemblies. Flexible hoses are connected at the fuel tank and the EVAP canister. The pipe should be inspected occasionally for leaks, kinks, or dents and repaired as required.

Repair the EVAP pipe in sections using brazed seamless steel tubing meeting GM specification 123M or equivalent or hose identified with the word Fluoroelastomer. Hose not so marked could cause failure or failure to meet emission standard.

Important: 

•	Do not use copper or aluminum tubing to replace steel tubing. Those materials do not have satisfactory durability to withstand normal vehicle vibrations.

•	Do not use rubber hose within 100 mm (4 in) of any part of the exhaust system or within 250 mm (10 in) of the catalytic converter. The replacement hose's inside diameter must match the steel tubing outside diameter.

1. In repairable areas, cut a piece of fuel hose 100 mm (4 in) longer than the portion of the line being removed. When more than a 150 mm (6 in) length of pipe is removed, use a combination of steel tubing and hose so that the entire hose length will not be more than 250 mm (10 in).
2. Cut the ends of the pipe remaining on the vehicle square by using a tubing cutter. By using the first step of a double flaring tool, form a bead on the ends of both pipe sections. If the pipe is too corroded to withstand bead operation without damage, the pipe should be replaced. If a new section of pipe is used, form a bead on both ends.
3. Use screw type hose clamps GM P/N 2494772 or equivalent. Slide the clamps onto the pipe and push the hose 50 mm (2 inches) onto each portion of the fuel pipe. Tighten the clamps on each side of the repair.