Tools Required

J 38778 Door Trim Pad and Garnish Clip Remover

1. Remove the intermediate seat. Refer to Rear Bench Seat Replacement in Seats.
2. Remove the driver's door stepwell lamp cover retaining screw.
3. Remove the stepwell lamp assembly from the body side lower storage pocket.



4. Use the J 38778 in order to remove the body side front lower trim panel from the vehicle.

1. Install the body side front lower trim panel to the vehicle:

1.1.	Align the fasteners.

1.2.	Snap the fasteners into place.

2. Install the driver's door stepwell lamp assembly to the body side lower storage pocket.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the stepwell lamp cover retaining screw.

Tighten
Tighten the stepwell lamp cover retaining screw to 2 N·m (18  lb  in).

4. Install the intermediate seat. Refer to Rear Bench Seat Replacement in Seats.