Striker Bolt Replacement - Sliding Door Front for Chevrolet Astro - 2WD 1998

Tools Required

J 29843-9 Door Lock Striker and Seat Belt Torx Wrench

1. Remove the shoulder belt guide bolt from the door pillar. Refer to Front Seat Shoulder Belt Guide Adjuster Replacement .
2. Pull the trim panel forward and reach behind the trim panel to the striker bolt nut  in order to remove the screw at the bottom of the door pillar trim.



3. Remove the striker bolt (4).
4. Remove the striker nut (1).

1. Install the striker nut to the inside of the door pillar.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.




2. Install the striker bolt (4) and insulator.

Tighten
Tighten the striker bolt to 67 N·m (49 lb ft).

3. Install the trim panel to the door pillar with a screw.
4. Install the shoulder belt guide bolt to the door pillar. Refer to Front Seat Shoulder Belt Guide Adjuster Replacement .