Tools Required

Important: The balance shaft and the front bearing are serviced only as a package. Do not remove the bearing from the balance shaft.

1. Remove the balance shaft. Refer to Balance Shaft Replacement .
2. Use the J 38834 and the J 26941 in order to remove the balance shaft rear bearing.

2.1.	Install the J 26941 legs behind the balance shaft rear bearing and secure.

2.2.	Install the J 38834-1 with the short threaded end through the front of the engine block.

2.3.	Install the J 38834-1 into the J 26941.

2.4.	Slide the J  38834-2 onto the J 38834-1 and into the balance shaft bore of the engine block.

2.5.	Install the bearing, washer and nut on the J 38834-1.

2.6.	Hold the J 38834-1 and turn the nut clockwise until the bearing is removed.

Tools Required

J 38834 Balance Shaft Service Kit

1. Dip the balance shaft rear bearing in clean engine oil before installation.
2. Use the J 38834 in order to install the balance shaft rear bearing.

2.1.	Install the J 38834-3 onto the short threaded end of the J 38834-1.

2.2.	Install the nut, washer, and bearing on the long threaded end the J 38834-1.

2.3.	Install the J 38834-2 so that the smaller diameter will be facing the front, onto the J 38834-1.

2.4.	Install the J 38834-2 on the inside of the balance shaft front bearing bore.

2.5.	Install the balance shaft rear bearing on the J 38834-1.

2.6.	Position the balance shaft rear bearing.

2.7.	Hold the J 38834-1 with a wrench and turn the nut clockwise until the balance shaft rear bearing is installed.

3. Install the balance shaft. Refer to Balance Shaft Replacement .