Removal Procedure
- Disconnect the negative battery cable.
- Remove the engine cover. Refer to Engine Cover Replacement in Interior Trim.
- Remove the air cleaner outlet retaining nut (1).
- Remove the air cleaner outlet duct (2) from the throttle body assembly.
- Disconnect the IAT sensor harness connector.
- Loosen the air cleaner outlet duct from the MAF sensor.
- Remove the air cleaner outlet duct.
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
Installation Procedure
- Install the air cleaner outlet duct to the MAF sensor.
- Connect the IAT sensor harness connector.
- Install the air cleaner outlet duct (2) on the throttle body assembly.
- Tighten the retaining nut (1).
- Install the engine cover. Refer to Engine Cover Replacement in Interior Trim.
- Connect the negative battery cable.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the clamp to 4 N·m (35 lb in)
Tighten
Tighten the nut 2 N·m (18 lb in).
