Removal Procedure
- Drain the coolant to a level below the thermostat. Refer to Cooling System Draining and Filling .
- Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement in Engine Controls.
- Disconnect the ground lead from the coolant outlet.
- Remove the bolt/stud and the bolt on the coolant outlet.
- Remove the coolant outlet.
- Remove the thermostat.
- Clean all of the parts and the sealing surfaces.
Caution: In order to avoid being burned, do not service the engine while it is still hot. Service the engine when it is cool.
Installation Procedure
- Install the thermostat.
- Install the coolant outlet.
- Install the bolt and the bolt/stud.
- Install the ground lead to the bolt/stud.
- Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement in Engine Controls.
- Refill the coolant. Refer to Cooling System Draining and Filling .
- Start the engine. After the engine reaches normal operating temperature, check for coolant leaks.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the bolt and the bolt/stud to 25 N·m (18 lb ft).
