Tools Required

J 41352 Modular Column Holding Fixture

1. Install the trim cover protector (1) into the lower trim cover (2).



2. Install the upper trim cover (2).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the TORX® head screw (1).

Tighten
Tighten the TORX® screw to 1.5 N·m (13 lb in).





Important: The shift lever seal must be seated correctly in the trim covers.

4. Install the lower trim cover (1).
5. Install the 2 pan head tapping screws (2) into the lower trim cover.

Tighten
Tighten the pan head tapping screws to 3.5 N·m (31 lb in).




6. Remove the steering column and J 41352 from the vise.