Stop Lamps Always On Domestic
Step | Action | Value(s) | Yes | No | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
1 | Did you perform the Lighting Diagnostic System Check? | -- | Go to Step 2 | |||||||||||||
2 |
Do all of the stop lamps remain ON? | -- | Go to Step 3 | Go to Step 4 | ||||||||||||
3 | Disconnect the turn/hazard switch connector (part of C201). Does the center high mounted stop lamp remain ON? | -- | Go to Step 5 | Go to Step 6 | ||||||||||||
4 | Replace the Brake Pedal Position switch. Refer to Stop Lamp Switch Replacement in Hydraulic Brakes. Is the repair complete? | -- | Go to Step 12 | -- | ||||||||||||
5 | Repair the short to voltage in CKT 17 (WHT) between the following components:
Is the repair complete? | -- | Go to Step 12 | -- | ||||||||||||
6 | Inspect the other stop lamps with the turn/hazard switch connector (part of C201) still disconnected. Does the left side stop lamp remain ON? | -- | Go to Step 7 | Go to Step 8 | ||||||||||||
7 | Repair the short to voltage in CKT 18 (YEL) between the following components:
Is the repair complete? | -- | Go to Step 12 | -- | ||||||||||||
8 | Inspect the other stop lamps with the turn/hazard switch connector (part of C201) still disconnected. Does the right side stop lamp remain ON? | -- | Go to Step 9 | Go to Step 10 | ||||||||||||
9 | Repair the short to voltage in CKT 19 (DK GRN) between the following components:
Is the repair complete? | -- | Go to Step 12 | -- | ||||||||||||
10 | Inspect all of the stop/lamps with the turn/hazard switch connector (part of C201) still disconnected. Do any of the stop lamps remain on? | -- | Go to Step 2 | Go to Step 11 | ||||||||||||
11 | Replace the turn/hazard switch. Refer to Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle in Steering. Is the replacement complete? | -- | Go to Step 12 | -- | ||||||||||||
12 | Operate the system in order to verify the repair. Did you correct the condition? | -- | System OK | Go to Step 2 |
Stop Lamps Always On VE1
Step | Action | Value(s) | Yes | No | ||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
1 | Did you perform the Lighting Diagnostic System Check? | -- | Go to Step 2 | |||||||||||
2 |
Do all of the stop lamps remain ON? | -- | Go to Step 4 | Go to Step 3 | ||||||||||
3 | Replace the Brake Pedal Position switch. Refer to Stop Lamp Switch Replacement in Hydraulic Brakes. Is the repair complete? | -- | Go to Step 5 | -- | ||||||||||
4 | Repair the short to voltage in CKT 17 (WHT) between the following components:
Is the repair complete? | -- | Go to Step 5 | -- | ||||||||||
5 | Operate the system in order to verify the repair. Did you correct the condition? | -- | System OK | Go to Step 2 |
